Zeiss i.Profiler plus - Network and Printer Setup

Installation
000000-1520-928_GA_EN_021013
24
• Confirm your selection by clicking on OK. The Confirm Desktop
Change dialog appears.
• Confirm with OK.
Alternatively you can proceed as follows:
• Click on the symbol on the right side of the task bar.
• Select Graphics Properties… from the menu bar.
• Select "Intel
®
Dual Display Clone" and then "Notebook + Monitor" in the
Output To field.
• Double-click on the Save Configurations program icon on the Microsoft
Windows desktop to save the new configuration. The device will restart.

Always switch on the external monitor before switching on the
i.Profiler
® plus
otherwise the monitor will not be registered when
booting the device.
Integrating the i.Profiler
® plus
into an existing network
via DHCP
• Connect the i.Profiler
® plus
to the practice network (LAN) using a network
cable.
• After the start, quit the i.Profiler
® plus
software by pressing the Close
Application button in the Shut Down window and switch to the
Microsoft Windows desktop (administrator rights required).
• Double-click the Network Configurator symbol on the desktop. The
Network Configuration Tool dialog appears.
• Select the Ethernet connection used by your network in the Network
Adapter field. The left connection is marked [00000000], the right
connection [00000001].
• Select Activate DHCP.
• Click on the Change IP button. The message "Change to DHCP was
successful" appears.
• Close the Network Configurator.
• Double-click on the Save Configurations program icon on the Microsoft
Windows desktop to save the new configuration. The device will restart.