Installation
000000-1520-928_GA_EN_021013
Configuration of a network memory device
WARNING - RISK OF ELECTRIC SHOCK
If the NAS device is not supplied with electricity via an isolation transformer
it must be located at least 1.5 m from the patient to prevent the latter from
touching the device with any part of his/her body during the examination.
Nor should the operator touch the patient and the peripheral device
simultaneously during an examination. If this warning is not observed, the
patient and/or operator is liable to receive an electric shock.
This section contains instructions for configuring a network attached storage
device or NAS device for use with the i.Profiler
® plus
. These instructions
specify the requirements and recommendations for the NAS device. Either a
Carl Zeiss Vision NAS device or an NAS device from a preferred supplier that
satisfies these requirements (generic NAS device) may be used. The NAS
device may be plugged directly into the Ethernet connection of the
i.Profiler
® plus
or to your practice network (LAN). Both methods of connection
are described in these instructions.
Once the NAS device has been installed and configured for use with the
i.Profiler
® plus
, it functions as a network server primarily for archiving
purposes. The instructions for the use of a network server also apply
analogously to the NAS device.
To Next Page
Loading...
