Zeiss i.Profiler plus - Integrating the I.profiler Plus into an Existing Local Network

Installation
000000-1520-928_GA_EN_021013
25
Integrating the i.Profiler
® plus
into an existing local
network
• Connect the i.Profiler
® plus
to the practice network (LAN) using a network
cable.
• Switch the i.Profiler
® plus
on. After the start, quit the i.Profiler
® plus
software by pressing the Close Application button in the Shut Down
window and switch to the Microsoft Windows desktop (administrator
rights required).
• Double-click the Network Configurator symbol on the desktop. The
Network Configuration Tool dialog appears.
• Select the Ethernet connection used by your network in the Network
Adapter field. The left connection is marked [00000000], the right
connection [00000001].
• Enter the new IP address in the IP Address field. The three first digit
blocks must conform to the digit blocks of your network. The last digit
block can be selected, but the number must be unique.
• Change the subnet mask in the Subnet Mask field.
• Click on the Change IP button. The message "The static IP was set
successfully." appears.
• If available, you should enter Gateway and DNS-Server.
• Now you can close the Network Configurator.
• Double-click on the Save Configurations program icon on the
Microsoft Windows desktop to save the new configuration. The device
will restart.