Zeiss i.Profiler plus - Printer Installation for the I.profiler Plus

Installation
000000-1520-928_GA_EN_021013
26
Printer installation for the i.Profiler
® plus
WARNING - RISK OF ELECTRIC SHOCK
The printer must be set up outside the patient environment (1.5 m from the
patient’s seat at the device) and plugged into a separate socket. The user
should not simultaneously touch the patient and the printer.
If the printer is to be operated in the patient environment, it must be
additionally connected via an isolation transformer.
CAUTION - RISK DUE TO FAULTY DATA
Only a PostScript-capable network printer may be used.
The i.Profiler
® plus
only supports PostScript
®
printers that can be connected
via the Ethernet or a printer server. A network-compatible PostScript printer
can be connected directly to the i.Profiler
® plus
(peer-to-peer) or over a
network.

Keep the user manual for the printer or printer server at hand. The
printer must be configured according to the instructions contained
in the user manual for the printer or printer server.