Zeiss i.Profiler plus - Explaining the I.profiler Plus Measurement Procedure to the Patient; Work Sequence

Operation
000000-1520-928_GA_EN_021013
41
Work sequence
The following work sequence is recommended:
• Explain the i.Profiler
® plus
measurement procedure to the patient.
• Open the patient database and enter the data of the patient to be
measured if it does not already exist (Patient Database window).
• Position the patient for measurement (see page 44).
• Select the patient to be measured in the database and start
measurements (Measurement window).
• Complete the measurements and evaluate your results using the preview
images (Preview window). Insofar as they are acceptable, save your
readings. Otherwise repeat the measurement.
• Analyze your readings (Review and Analysis windows).
• After analyzing the data, switch to the patient database to select the next
patient or enter new patient data.