Installation
000000-1520-928_GA_EN_021013
Installation of a generic NAS device
• Configure the NAS device using the device-specific manual as follows:
IP address: 192.168.100.7
Subnet mask: 255.255.255.0
Standard gateway: 0.0.0.0
• Generate a local directory on the NAS device.
• Generate a user account on the NAS device. It is recommended to use
the user name "Zeiss" and the password "November171846".
• If a Workgroup is available, it is recommended to name it "CZM".
• Release the local directory on the NAS device with reading and writing
rights for the user account previously generated.
Configuration of a generic NAS device on i.Profiler
® plus
• Switch the i.Profiler
® plus
on. After the start, quit the software by pressing
the Close Application button in the Shut Down window and switch to
the Microsoft Windows desktop (administrator rights required). The LAN
connection may be indicated in the task bar bottom right when the NAS
device is connected. Ignore this message for the time being.
• Open Windows Explorer and select Tools from the menu bar.
• Select Map Network Drive…. The Map Network Drive dialog
appears.
• Select the drive letter N:\ in the Drive field.
• Enter the IP address of the NAS device and the released directory in the
Folder field as follows:
\\192.168.100.7\"local directory"
• Make sure that the Reconnect at logon checkbox is selected.
• Confirm the entries by clicking on Finish.
• If required, the user name and password of the user account previously
generated on the NAS device must be re-entered.
• Double-click on the Save Configurations program icon on the Microsoft
Windows desktop to save the new configuration. The device will restart.
To Next Page
Loading...
