USING THE REMOTE CONTROL (CONTINUED)
IJ
Numbered Buttons
Used to select channels. When channels are selected
without use
of
the
ENTER
button, the Cable box will
automatically change to the selected channel in about 2
seconds.
NOTE:
If
you are entering 2
or
3 digit information, press
the numbered buttons within two seconds
of
each other.
IIiJ
ADJUST (left)
Functions as the AM/PM button on Zenith Decoder
Remote Control.
ADJUST (left) button
is:
______
button on
non-Zenith remote control.
ADJUST (right)
Functions as the Clock button on Zenith Decoder
Remote Control.
ADJUST (right) button
is:
______
button on
non-Zenith remote control.
msELECT
Functions as
Data
Entry button
on
Zenith Decoder
Remote Control. When used with the Parental Control,
Clear Entry, and Favorite Channel buttons, it allows
channels
to
be programmed into
or
out
of
the Channel
Scanning Sequence. Selected channels can also be
locked out.
SELECT
button
is:
______
button
on
non-Zenith remote control.
mMENU
8-4
Functions as Program button
on
Zenith Decoder
Remote Control. When used with the AM/PM and
Timer controls, it allows Decoder to
turn
on, select a
channel, then turn off automatically.
MENU
button
is:_______
button on
non-Zenith remote control.
To Next Page
Loading...
