CABLE
TVNCR
OPERATIONAL NOTES (CONTINUED)
REMOTE
CONTROL
OF
CA1V DECODER
Your TV remote control provides full remote control
of
"basic"
or
"unscrambled" cable channels within your TV's
tuning
capability. It may also be able
to
control the
Cable-TV decoder
or
other equipment supplied by the
cable
system operator
to
select "premium"
or
scrambled
channels. However, the remote control user fee charged
by
some cable companies may still apply. Check with
your
Cable System operator.
ZENITH
REDI-PLUG
Your TV has a Redi-Plug access
port
on
the back
of
the
cabinet. A plastic shield protects the access port. This
access port allows installation
of
a connector for certain
cable TV decoders which may be provided by cable
system operators using Zenith equipment.
If
you have a
need for the connector, your qualified Zenith service
representative can install it at a nominal charge.
BASE-TAC
REDI-PLUG
BASE-TAC
(TAC-
Tiered Addressable Code) is a type
of
converter/decoder available from cable.companies in
some areas.
When
used with a Zenith
TV
or
Zenith
VCR
which has a BASE-TAC Redi-Plug, it allows you to
view premium "unscrambled signal" channels while
retaining complete remote control
of
channel selection
through the
TV
or
VCR. Consult your local cable
company for availability in your area.
If
it is available
through your cable company, you can have
the
necessary
BASE-TAC connector installed (for a fee)
at
a Zenith
distributor
or
distributor-approved Zenith service center.
10-3
To Next Page
Loading...
