70-40 Main Bike Board (MBB)
Electrical
70
7. Remove bolts (x4) securing MBB to the tank
storage liner and collect washers (x4).
Tool: 6mm hex
CAUTION: Replace vibration-resistant
rubber isolator nuts if they are damaged or
worn.
Note: Do not over-tighten bolts.
8. Remove MBB.
Installation
1. Installation is the reverse of the removal
procedure.
Note: After replacing the MBB, the keys must
be reprogrammed. Locate your yellow key and
black keys and follow the key programming
procedure. See Motor Controller Firmware
Update, page 10.14.
To Next Page
Loading...
