Zero SR/S

20-22 Power Pack
Power Pack
20
13. Remove the power pack rear cover.
14. Remove nut securing the MBB (Main Bike
Board)/Contactor fuse holder to the high
voltage fuse bracket and capture plastic
washer. Tool: 14mm socket. Torque: Hand
15. Remove nut securing the DC/DC Converter
fuse holder to the high voltage fuse bracket
and capture plastic washer. Tool: 14mm
socket. Torque: Hand
16. Cut cable tie securing Battery Signal B+ Sense
Line harness.
Note: Replace cable tie during the installation
process.
17. Cut cable tie securing Battery Signal B- Sense
Line harness.
Note: Replace cable tie during the installation
process.
18. Disconnect Battery Signal B+ Sense Line
harness connector.