157
BALLAST WEIGHTS
F_02_26 F_02_82
FRONT BALLAST WEIGHTS
Weight
combination
(units)
Ballast weight mass
(kg)
2+2 4x50 200
3+3 6x50 300
5+5 10x50 500
7+7 14x50 700
Front can-type ballast weights are sus-
pended in the ballast weigh hanger.
They are locked against the side shifts
with a pin placed between the inner
weights. The other weights are then at-
tached to the inner ones with two
clamps.
Ballast weight combination 7+7 is
used at Z 11741 only
Note: After inserting the pin, the front
weights and the weight holder can be
used as a front hook for emergency res-
cuing.
FRONT THREE-POINT HITCH BAL-
LAST WEIGHTS
Circular weights
Weight
combination
(units)
Ballast weight mass
(kg)
beam+16 beam 8+16x28 456
The weights with the beam shall be sus-
pended at the lower tie rods of the front
three-point hitch. The task of those
weights consists in ensuring the tractor
longitudinal stability in case heavier at-
tached implements are suspended at the
rear three-point hitch.
To Next Page
Loading...
