87
TRACTOR RUNNING-IN
F_02_50 F_02_69 F_02_70
AFTER 10 HOURS
The warmed-up oil from the transmission
system is recommended to be pre-
filtered with a filtering unit of 20 micron
filtering capacity namely with sucking it
or draining it to the filtering unit.
The transmission system if fitted with 5
draining holes (1 – clutch box, 1 – gear
box, 3 – final drives).
AFTER 10 HOURS
Remove and clean the magnet (which is a component of the cover) and hydraulic
pump suction and gearbox filter strainer elements (1) see Fig.F_02_69.
Wash the two parts in gasoline and after their dripping, put them back.
Replenish oil (in conformance with the assumed the tractor utilization – see the
Chapter ”Hydraulic system” of this Manual).
For measuring the oil level in the gearbox, stop the engine and insert the plug with
dipstick (2) into the tube.
Gearbox oil level ¨Tractor employment
A
minimum standard operation
B normal
standard operation
C
+7 l (higher) operation on a slope
D
+15 l – maximum aggregation with the machinery of high external offtake
of oil
Since that moment you can use the whole hydraulic system without any restriction.