Zetor 117 41 forterra turbo - Setting up the Valve Clearancez 8641 - Z 11441; Setting up the Valve Clearance Z 11741; Setting-Up the Injectors Z 8641 - Z 11441

189
SETTING-UP OPERATIONS
F276 F_02_203a F278
SETTING UP THE VALVE CLEARANCE
Z 8641 - Z 11441
The valve clearance should be set up in
the cold engine. The correct clearance in
the admission and exhaust valves is
0,25 ± 0,05 mm.
Alternation of the rocker arms motion:
Cylinder rocker
arm alternation:
Cylinder to be
adjusted:
14
23
32
41
SETTING UP THE VALVE
CLEARANCE Z 11741
The valve clearance should be set up in
the cold engine. The correct clearance in
the admission and exhaust valves is
0,30 ± 0,05 mm.
Alternation of the rocker arms motion:
Cylinder rocker
arm alternation:
Cylinder to be
adjusted:
16
52
34
61
25
43
SETTING-UP THE INJECTORS
Z 8641 - Z 11441
The service opening pressure of the in-
jectors is 22,0 - 0,8 MPa. The opening
pressure of injectors should be set up to
the upper limit of the range (22,0 MPa)
with spacing washers (1) of different
thickness, which should be put under the
spring (2). The Correct position of the
injection nozzle (3) is determined with
the positioning pins at the sealing sur-
face. The tightening torque of the fixing
nut (4) is 50 to 60 Nm. Before tightening
the nut, push the nozzle against the
spring with leaning it against the wooden
block