Zetor 117 41 forterra turbo - Checking the Lights in the Tractor Hood for Proper Setting-Up; Setting up the Lights in the Tractor Hood

206
ELECTRICAL SYSTEM
F_02_145 F_02_126
CHECKING THE LIGHTS IN THE TRACTOR HOOD FOR PROPER SETTING-UP
When making the check on the testing wall, the tractor must be placed on the hori-
zontal surface and the tires must be inflated to the prescribed pressure. The basic
vertical setting is 3,5 % with the tractor operating weight. In the horizontal direction,
the light beams have to be parallel to the longitudinal tractor axis of symmetry.
I
- Distance of testing wall from the headlights (5 m)
h
- Height of the headlight center over the road
∆
∆∆
∆h
- Headlight inclination (-3,5 %) distance of testing wall = 17,5 cm
α
αα
α
- Asymmetric light picture raising (15%)
SETTING UP THE LIGHTS IN THE
TRACTOR HOOD
The setting-up shall be performed with
the two screws (1) simultaneously for the
vertical and horizontal beam directions:
Horizontally ± 2°; vertically +1° up to -6°.
Each of the headlights shall be set up
separately. The faulty bulb shall be re-
placed from the rear part of the light
parabola. Because of the lack of room,
release and shift or remove the starting
battery.