Zetor 117 41 forterra turbo - Page 218

218
SCHEDULED TECHNICAL MAINTENANCE
LUBRICATING CHART TRACTORS Z 8641 - Z 11741
Pos. Lubricating point - inspection Type of charge
ENGINE
1 Exchange of engine oil (engine oil filling hole) see (tab. 1)
2 Exchange of engine oil (engine oil drain hole) -
3 Engine oil filter replacement (engine oil filter) -
ENGINE ACCESSORIES
4 Exchange of cooling liquid (cooling liquid filling hole) see (tab. 8, 9)
5 Lubrication of foot and hand accelerator, Stop Device see (tab. 5)
TRANSMISSIONS
6 Gearbox (filling hole) see (tab. 2)
7 Gearbox (drain hole) -
8 Clutch box (drain hole) -
9 Final drive (drain holes - 3x) -
10 Front P.T.O shaft gear box (filling hole) see (tab. 2)
11 Front P.T.O. shaft gear box (drain hole) -
AXLES AND STEERING
12 Front driving axle (filling hole) see (tab. 3)
13 Front driving axle (drain hole) -
14 Front driving axle reducers (filling and drain hole) see (tab. 3)
15 Steering pivot grease nipples (2x) see (tab. 5)
16 Steering oil tank see (tab. 4)
17 Steering lever ball joints see (tab. 5)
18 Propeller shaft grooves and cross-head pins see (tab. 5)
19 Front axle console center pin grease nipple (2x) see (tab. 5)
HYDRAULIC SYSTEM
20 Hydraulic system additional cylinder pins see (tab. 5)
21 Push-pull cable of pick up hitch, hand parking brake see (tab. 5)
22 L.H. lifting arm pin see (tab. 5)
23 Front three-point hitch pins see (tab. 5)
24 Automatic coupling mouth for trailers see (tab. 5)
25 Single-axle trailer locking pin see (tab. 5)