131
WHEEL TRACK CHANGE
E502
SETTING THE STOPS ON THE FRONT
DRIVING AXLE
Set the stops after every change of the
wheel track of the front driving axle in
accordance with the provided tables after
loosening the nut (2) and releasing or
tightening the screw (1) to value “A”. Af-
ter setting the screw (1) tighten the nut
(2) with the torque of 100 - 150 Nm.
Tire 11,2-24 12,4-24 13,6R24
Treads A (mm) A (mm) A (mm)
1525 60 61
1610 59
1620 46 55
1680 47
1690 50
1760 43
1770 39
1825 32
1835 34
1910 27
1920 27
In the case of tractors equipped with the braked front axle after a change of
the front wheel track to the value of 1910 or 1920 mm it is necessary after
setting the stop screws to the value of 27 mm to check the distance between
the threaded end of the wheel screw and the wheel hub.
This distance must be at least 4 mm!
To Next Page
Loading...
