134
WHEEL TRACK CHANGE
E506
REAR WHEEL TRACK CHANGE
Used tyres Tyre width
in mm
Adjustable
wheel track
13.6-36 348 1350 - 1800
16.9-30 429 1425 - 1800
16.9R30 429 1425 - 1800
480/70R30 479 1425 - 1800
18.4 -30 467 1500 - 1800
16.9-34 429 1425 - 1800
16.9R34 429 1425 - 1800
480/70R34 429 1425 - 1800
18.4-34 467 1500 - 1800
18.4R34 467 1500 - 1800
The wheel track of 1500 is adjusted by
the manufacturer as standard.
The rear wheel track is adjusted by
changing the position of the rim and disc
with the rear part of the tractor lifted.
The wheels must turn freely.
Before the lifting do not forget to secure the tractor against moving by wedg-
ing the front wheels!
After changing the wheel track tighten all the screws connecting the disc with the rim
with the torque of 200 - 220 Nm and the nuts of the screws connecting the disc with
the wheel shaft with the torque of 400 - 470 Nm.
After every loosening of a rim connection tighten the screws to the prescribed
value.
After driving 100 m with the tractor without load re-tighten the connections with the
prescribed torque.
After loading the tractor re-tighten the connections after 3 hours of work.
After 10 hours of work check the tightening of the nuts of discs and wheel rims
again.
Until reaching the first 100 hours of work perform frequent checks of tightening the
nuts of the discs and rims of the front and rear wheels (at least 6 times in the
course of the first 100 hours of work).
Then, always check the tightening of the nuts of the discs and rims of the front and
rear wheels after every 100 hours of work.
To Next Page
Loading...
