64
DRIVING OPERATION
G204 G205 G206
IF THE ENGINE WILL NOT START
Return the key to the “0” position, wait
for 30 seconds and repeat starting.
6 starting cycles are permissible at the
most (one cycle is 15 s starting and 30 s
interruption). Further starting of the en-
gine is only possible when the started
has cooled down to the ambient tem-
perature.
Never support the stopping en-
gine with the starter motor.
There is a danger of damaging
the starter motor.
INDICATION OF ERRORS OF THE
GLOWING SYSTEM
An error of the glowing system is indi-
cated by flashing of the glowing indicator.
- If at engine standstill the glowing indica-
tor flashes once a second, the glowing
will occur in the emergency mode as at
low temperatures regardless of the
coolant temperature.
- If at engine standstill the glowing indica-
tor flashes twice a second, the glowing
is off (out of operation).
- If the glowing indicator flashes perma-
nently during engine operation, the
glowing controller is faulty and the glow-
ing has not been finished. This failure
must be removed immediately as the
battery might get discharged.
HANDLING THE STARTER MOTOR
It is forbidden to start the en-
gine by short-circuiting the
starter motor terminals.
The tractor can only be started
from the driver’s seat!
During any handling or repair of
the started motor the minus pole
of the battery must be discon-
nected and all the shifting levers,
incl. PTO must be moved to the
neutral position. Starter motor
contacts are covered with a cap.
To Next Page
Loading...
