181
MAINTENANCE INSTRUCTIONS
E733 G731 G735
LUBRICATION AND FILLING POINTS
OF THE FRONT DRIVING AXLE
1 - Lubricating nipple of the kingpin.
2 - Sliding bearings (2 pieces) of the
front driving axle
3 - Drain opening of the final drive hous-
ing oil
4 - Filling and inspection opening of final
drive housing oil (after removing of
the inspection screw the oil level
must reach the bottom edge of the
inspection opening)
FILLING, INSPECTION AND DRAIN
OPENING OF OIL OF THE FRONT
WHEEL REDUCERS
Oil is checked, filled and drained through
one opening after turning of the reducer
in accordance with the figure.
1. Checking the oil level - opening on
the horizontal axis of the reducer
(after unscrewing of the inspection screw
the oil level must reach the bottom edge
of the inspection opening).
2. Oil filling - opening at the top
3. Draining oil of unbraked axle - open-
ing at the bottom
4. Draining oil of braked axle - opening
at the bottom
BRAKE LIQUID REPLENISHMENT
The tank is installed at the left-hand side
of the tractor in front of the cab and it is
accessible after lifting of the front hood
and lifting of the wing.
Maintain the brake liquid level in the
range of 3/4 of the tank content (max.
level) and 1/2 of the tank content (mini-
mum level).
When handling brake liquid, keep
absolute cleanness. Check the
brake liquid level daily before
starting your work.
To Next Page
Loading...
