89
CPSW Menu Structure
d. The paging format “Alerts” is used to add various alert tones to your pages.
The following list shows the page character used by the operator to generate
each Alert function:
(0) Beep alert
(D) Delay function
(1) Slow siren alert
(2) Fast siren alert
(3) Hi/Lo warble alert
(4) Fast warble alert
For example, assuming the “Alerts” paging format has been assigned to
leading digit “A”, keying A4 on the Model 4010 paging/DTMF keypad enters
the Fast Warble alert on the paging stack.
Beep Alert (0) and Delay (D) function are configurable:
• Tone Frequency configures the tone for the Beep Alert. (When
programming a delay, you must use a frequency even though no tone is
being processed.)
• ON Duration sets the length of each beep tone.
• OFF Duration sets the delay between each beep tone.
• Count / Delay Time sets the number of beeps for the Beep Alert or the
delay in seconds for the Delay function.
The tones for Alert (1) through (4) are predefined in the console; only their
duration is configurable (by setting Alert Duration).
5. If you have additional Leading Digits to assign, repeat this procedure. If you are
finished, click Done.
Edit Custom Calls
Custom Calls defines your own custom two-tone pages for the paging format “Custom
(Plectron)”. If you have assigned a leading digit to a custom paging format (see To assign
and configure a paging format for a leading digit on page 88), then you must configure
custom calls here.
Warning! When you have configured a Leading Digit and you select
another Leading Digit, the configuration changes you made
are automatically applied. Clicking Cancel only cancels
configuration changes for the currently selected Leading Digit.
Likewise, clicking Revert only reverts configuration changes
for the currently selected Leading Digit.
Note The “Edit Custom Calls” menu item is only enabled when there is a
leading digit in the “Paging Format Configuration” dialog that has
been defined as “Custom (Plectron)”. Otherwise, this menu item is
disabled and cannot be accessed to configure any data in the area.
STOP
To Next Page
Loading...
