Ziehm Imaging, Inc. QUANTUM User Manual

Section 2.0
MAN 06–0017H ZIEHM QUANTUM User’s Manual Page 21 of 220
CAUTION
Always set the ON/OFF switches on the flat-screen monitors to ON in order to
ensure that the monitors are switched on automatically during power-up of the
system. If power is turned off after initial turn on of the system, operator must
switch off both monitors and then back on again at the same time, to make sure
both monitors start at the same time.
Fig 2.2: Power Switch On Flat Panel Monitors
2.5.3 MONITOR POSITION
Movement of the Flat-Screen Monitors
The flat-screen Monitors are mounted on a pivot and can be swiveled by approximately 300
degrees to the right or to the left to position the monitor on the right or left side of the C-Arm
Profile depending on the doctor’s needed viewing angle.
CAUTION
The standard mounting of the Flat-screen Monitors are on a pivot and can be
swiveled approximately 180 degrees; please use caution when moving the monitors
as collision with other devices may occur as well as collision with the Desk View
Touch Screen.

Ziehm Imaging, Inc. QUANTUM Specifications

General

Brand	Ziehm Imaging, Inc.
Model	QUANTUM
Category	Science Education products
Language	English