Section 10.0
MAN 06–0017H
ZIEHM QUANTUM User’s Manual Page 156 of 220
Escape
The ESCAPE button allows the user to leave the Archive screen at any time.
If images were selected for any one or all the patients in the Archive list and the
user Escapes from this screen the image marker will be removed and the use
will have to re-establish the image markers before they can export images.
10.12 CONFIGURING SYSTEM: (CONFIG)
The system has certain functions and values of image operations that can be set as defaults at start
up and for common setting for such functions as noise and edge enhancement which have preset
noise processing levels.
The CONFIGURATION screen has two basic functions, to support user operations and settings
and for administrator use in performing system permissions, DICOM settings, and disc utilities.
We will discuss the Administrative functions first.
There must be at least one administrator for the system to allow input of system permissions and
setup of DICOM addresses, USB log of Image export activities, and erasing the hard drive. (See
Section 10.8 Log In)
The following items can only be set by the system Administrator; User can not set these listed
functions.
• Erase Disc: this function will erase all the patient data from the system hard drive.
• DICOM 1 and DICOM 2 Settings
• Set user permission/passwords for the log in file
• Save export log to USB
• Clear Export Log file
• All of the configuration values for image capture and processing
The ERASE disk operation must be done only in extreme cases where you need to remove all
patient data from the system image disk.
This operation is considered a destructive operation in that it will remove all the patient
information from the system and cannot be retrieved after it has been erased.
CAUTION
The Administrator should use caution when performing the Erase Disk operation as this
operation will remove all the patient information from the system and cannot be retrieved
after it has been erased.
10.12.1 ERASING DISK AND ACTIVATING DATABASE AFTER ERASE DISK OPERATION
When using the ERASE DISK function the user must perform this in the following
manner to avoid errors in the database.
• Never perform this if the patient images have not been saved/removed from the
C-arm memory as they will be lost. Once the images are erased they cannot be
retrieved.
• Once all patient images have been exported and are safe the administrator should
To Next Page
Loading...
Need help?
General