ZKTeco SpeedFace-V5L TI User Manual

SpeedFace-V5L [TI] User Manual
Page | 15 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
Verification Mode 3.7
3.7.1 Palm Verification
 1: N Palm Verification mode
In this verification mode, the device compares the palm image collected by the palm collector with all the
palm data in the device.
The device automatically distinguishes between the palm and the face verification mode as the user
places his/her palm in the scanning area. Then the palm image is collected by the palm collector, and the
device matches the collected palm image with all the registered palm and returns an output.
 1: 1 Palm Verification mode
Click the button on the main screen to enter 1:1 palm verification mode and input the user ID and
press [OK], as shown in image below.

ZKTeco SpeedFace-V5L TI Specifications

General

Device Type	IP Access Controller
Model	SpeedFace-V5L TI
Fingerprint Capacity	10, 000
Card Capacity	10, 000
RFID Capacity	10, 000
Transaction Capacity	200, 000
Logs Capacity	200, 000
Display	5-inch Touch Screen
Wiegand Signal	Wiegand Input/Output
Temperature Detection	Yes
Palm Capacity	3, 000
Communication	TCP/IP, Wi-Fi
Interfaces	RS485, USB Host
Authentication Method	Face, Palm, Card, Fingerprint, Password
Face Recognition Speed	<0.3s
Power Supply	12V 3A
Face Capacity	6, 000 (1:N)