ZKTeco SpeedFace-V5L TI User Manual

SpeedFace-V5L [TI] User Manual
Page | 17 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
3.7.2 Fingerprint Verification
 1: N fingerprint verification mode
In this verification mode, the device compares the fingerprint that is being pressed onto the fingerprint
reader with all the fingerprint data that is stored in the device and returns an output.
The device enters the fingerprint authentication mode when a user presses his/her finger onto the
fingerprint scanner.
NOTE: Please follow the correct way to place your finger onto the sensor. For details, please refer to Finger
Positioning
Verification is successful. Verification is failed.
 1: 1 fingerprint verification mode
In this mode, the device compares the fingerprint that is being pressed onto the fingerprint reader with
the fingerprints that are linked to the User ID input via the virtual keyboard.
Users may try verifying their identities with 1:1 verification mode when they cannot gain access with 1: N
authentication method.
Click the button on the main screen to enter 1:1 fingerprint verification mode and input the user ID
and press [OK].

ZKTeco SpeedFace-V5L TI Specifications

General

Device Type	IP Access Controller
Model	SpeedFace-V5L TI
Fingerprint Capacity	10, 000
Card Capacity	10, 000
RFID Capacity	10, 000
Transaction Capacity	200, 000
Logs Capacity	200, 000
Display	5-inch Touch Screen
Wiegand Signal	Wiegand Input/Output
Temperature Detection	Yes
Palm Capacity	3, 000
Communication	TCP/IP, Wi-Fi
Interfaces	RS485, USB Host
Authentication Method	Face, Palm, Card, Fingerprint, Password
Face Recognition Speed	<0.3s
Power Supply	12V 3A
Face Capacity	6, 000 (1:N)