ZKTeco SpeedFace-V5L TI User Manual

SpeedFace-V5L [TI] User Manual
Page | 82 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
 Software side
Login to ZKBioAccess MTD software, click System > Communication > Communication Monitor to set
the ADMS service port, as shown in the figure below:
Add Device on the Software 15.2
Add the device by searching. The process is as follows:
1） Click Access Control > Device > Search Device, to open the Search interface in the software.
2） Click Search, and it will prompt [Searching……].
3） After searching, the list and total number of access controllers will be displayed.
4） Click [Add] in operation column, a new window will pop-up. Select Icon type, Area, and Add to
Level from each dropdown and click [OK] to add the device.

ZKTeco SpeedFace-V5L TI Specifications

General

Device Type	IP Access Controller
Model	SpeedFace-V5L TI
Fingerprint Capacity	10, 000
Card Capacity	10, 000
RFID Capacity	10, 000
Transaction Capacity	200, 000
Logs Capacity	200, 000
Display	5-inch Touch Screen
Wiegand Signal	Wiegand Input/Output
Temperature Detection	Yes
Palm Capacity	3, 000
Communication	TCP/IP, Wi-Fi
Interfaces	RS485, USB Host
Authentication Method	Face, Palm, Card, Fingerprint, Password
Face Recognition Speed	<0.3s
Power Supply	12V 3A
Face Capacity	6, 000 (1:N)