ZKTeco SpeedFace-V5L TI User Manual

SpeedFace-V5L [TI] User Manual
Page | 57 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
Detection Management 8.7
Click Detection Management on the System interface to configure the Detection Management settings.
Function Description
Function Name
Description
Enable temperature
screening with
infrared
To enable or disable the infrared temperature measurement.
When this function is enabled, users must pass the temperature screening in
addition to identity verification before the access is granted.
To measure body temperature, user’s
faces must be aligned with the
temperature measurement area.
High temperature
alarm threshold
To set the value of the alarm threshold for high body temperature.
When
the temperature measured during verification is higher than the set
value, the device will give a prompt and audio alarm.
The default alarm threshold is 37.30°C.
Temperature over
the range; access
denied
When enabled, if the user’s body temperature measured is above (or below)
the alarm threshold, the user will not be granted access even if his/her
identity is verified.
When disabled, access is granted to the user if
his/her identity is verified,
regardless of his/her body temperature.

ZKTeco SpeedFace-V5L TI Specifications

General

Device Type	IP Access Controller
Model	SpeedFace-V5L TI
Fingerprint Capacity	10, 000
Card Capacity	10, 000
RFID Capacity	10, 000
Transaction Capacity	200, 000
Logs Capacity	200, 000
Display	5-inch Touch Screen
Wiegand Signal	Wiegand Input/Output
Temperature Detection	Yes
Palm Capacity	3, 000
Communication	TCP/IP, Wi-Fi
Interfaces	RS485, USB Host
Authentication Method	Face, Palm, Card, Fingerprint, Password
Face Recognition Speed	<0.3s
Power Supply	12V 3A
Face Capacity	6, 000 (1:N)