ZKTeco SpeedFace-V5L TI User Manual

SpeedFace-V5L [TI] User Manual
Page | 76 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
Duress Options 11.6
Once a user activates the duress verification function with specific authentication method(s), and when
he/she is under coercion and authenticates using duress verification, the device will unlock the door as
usual, but at the same time, a signal will be sent to trigger the alarm.
On Access Control interface, tap Duress Options to configure the duress settings.
Function Description
Function Name
Description
Alarm on Password
When a user uses the password verification method, an alarm signal will be
generated only when the password verification is successful, otherwise there
will be no alarm signal.
Alarm on 1:1 Match
When a user uses any fingerprint to perform the 1:1 verification, an alarm signal
will be generated only when the 1:1 verification is successful, otherwise there
will be no alarm signal.
Alarm on 1:N Match
When a user uses any fingerprint to perform 1:N verification, an alarm signal will
be generated only when the 1:N identification is successful, otherwise there will
be no alarm signal.
Alarm Delay (s)
Alarm signal will not be transmitted until the alarm delay time is elapsed. The
value ranges from 1 to 999 seconds.
Duress Password
Set the 6-digit duress password. When the user enters this duress password for
verification, an alarm signal is be generated.

ZKTeco SpeedFace-V5L TI Specifications

General

Device Type	IP Access Controller
Model	SpeedFace-V5L TI
Fingerprint Capacity	10, 000
Card Capacity	10, 000
RFID Capacity	10, 000
Transaction Capacity	200, 000
Logs Capacity	200, 000
Display	5-inch Touch Screen
Wiegand Signal	Wiegand Input/Output
Temperature Detection	Yes
Palm Capacity	3, 000
Communication	TCP/IP, Wi-Fi
Interfaces	RS485, USB Host
Authentication Method	Face, Palm, Card, Fingerprint, Password
Face Recognition Speed	<0.3s
Power Supply	12V 3A
Face Capacity	6, 000 (1:N)