ZKTeco SpeedFace-V5L TI User Manual

SpeedFace-V5L [TI] User Manual
Page | 42 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
• When the WIFI is connected successfully, the initial interface will display the Wi-Fi logo.
Add WIFI Network Manually
The WIFI can also be added manually if the required WIFI is not displayed on the list.
NOTE: After successfully adding the WIFI manually, follow the same process to search for the added WIFI
name. Click here to view the process to search the WIFI network.
WIFI Enabled: Tap on the required
network from the searched network list.
Tap on the password field to enter the
password, and then tap on Connect to
WIFI (OK).
Tap on Add WIFI Network to add the WIFI
manually.
On this interface, enter the WIFI network
parameters. (The added network must

ZKTeco SpeedFace-V5L TI Specifications

General

Device Type	IP Access Controller
Model	SpeedFace-V5L TI
Fingerprint Capacity	10, 000
Card Capacity	10, 000
RFID Capacity	10, 000
Transaction Capacity	200, 000
Logs Capacity	200, 000
Display	5-inch Touch Screen
Wiegand Signal	Wiegand Input/Output
Temperature Detection	Yes
Palm Capacity	3, 000
Communication	TCP/IP, Wi-Fi
Interfaces	RS485, USB Host
Authentication Method	Face, Palm, Card, Fingerprint, Password
Face Recognition Speed	<0.3s
Power Supply	12V 3A
Face Capacity	6, 000 (1:N)