Zmorph FAB - Page 15

zmorph3d.com 15
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
 Straighten the tip of

Wait till extruder reaches
the proper temperature.
The yellow HEATING sign
will change colour from
yellow to green.
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
PARK
TOOL
BACK

guide hole on top of the
extruder.

until you feel it has been
grabbed by extruder drive
gear.
Wait until the material

Tap the feed button again if
necessary.
Tap the LOAD/UNLOAD menu. Tap the bottom arrow on the
screen to feed 80 mm of the

with LEFT description to do
that.

showing ‘80 mm’ you
can change the amount

15 or 5 mm.
NOTE
Single Extruder Toolhead 1.75mm
80mm 80mm 80mm