Zmorph FAB - Page 21

zmorph3d.com 21

left side guide hole on top of
the extruder.
Tap the ‘LOAD/UNLOAD’
menu.
Tap the bottom arrow on the
screen to feed 80 mm of the

with ‘LEFT’ description to do that.

until you feel it has been
grabbed by the extruder
drive gear.

into the right side guide
hole on top of the extruder.
Tap the bottom arrow on the
screen to feed 80 mm of the

with ‘RIGHT’ description to do
that.
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
PARK
TOOL
BACK
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
PARK
TOOL
BACK



or 5 mm.

until you feel it has been
grabbed by the extruder
drive gear.
    
out of the nozzle. Tap the feed
button again if necessary.
NOTE
Dual Extruder Toolhead
80mm
80mm
80mm
80mm
80mm
80mm