Zmorph FAB - Page 46

Zmorph Fab - QUICK START GUIDE 46
Help and suppo
Calibration result
inaccurate.
 Inaccurate result of
the auto calibration.
 Check if the work table is aligned correctly.
 Check if the X-axis is leveled correctly.
 Check the position of the Z-axis sensor.
 Restore the machine to factory default.
 Contact with Technical Support

exist.
 
 No reading from
internal SD Card.
 Internal uSD Card
is unplugged or
damaged.
 Check the uSD Card content.
 Check the uSD Card connection to mainboard.
 
 Contact with Technical Support.
  
corrupted.
 
 Contact with Technical Support.
In case of inappropriate machine behavior, take every precaution and disconnect the machine from the

