Product Manual - ZMORPH i500 back to table of content
>>
23
Zmorph Dual Drive Dual Extruder
Hotend
Machine specication
it has a build in Nozzle Lifting System which
controls the change of the left and right
nozzle during the work. It is equiped with two
separate nozzles, Zmorph Build Hotend with
0.4 mm nozzle and Zmorph Support Hotend
with 0.6 mm nozzle
Zmorph Dual Drive Dual Extruder has
two separate hotends, it can be easily
disconnected and replaced. As deafult we
have on left Zmorph Build Hotend with 0.4
mm nozzle and on right a Zmorph Support
Hotend with 0.6 mm nozzle
To Next Page
Loading...
