NOTE
• Loops will be created and named “LOOPER_xxx”. The “xxx” in the loop name is a sequential number.
• When an SD card is loaded, loops cannot be deleted. Use a computer or other device to delete saved loops on
an SD card.
• When an SD card is loaded, the looper status will not be shown on the touchscreen.
• Changing the tempo while recording will delete the data being recorded.
• When an SD card is loaded, the recording time is from 2 seconds to 2 hours.
4.
When done creating a loop, press or touch .
The created loop will be saved on the SD card.
“New Loop File” appears, and a new loop can
be created.
NOTE
The settings made in “Setting the looper” on page 32 cannot be saved separately for different loops. The
same settings are used for all loops.
38
To Next Page
Loading...
