Reference [Phrase Looping]
ZOOM HD8/HD16
72
4. Press the [FUNCTION] key in the function/
transport section twice, to bring up the
indication “COPY PHRASE” on the first line of
the display. Then press the [ENTER] key.
The screen for specifying the copy destination phrase number
appears.
5. Turn the dial to select the phrase number for
the copy destination, and press the [ENTER]
key.
The display indication changes as follows.
NOTE
If a phrase already exists at the copy destination number, it will
be erased and replaced by the copy source phrase. Take care
not to accidentally delete a phrase.
6. To carry out the copy process, press the
[ENTER] key once more.
The phrase is copied, and the phrase screen appears again.
By pressing the [EXIT] key instead of the [ENTER] key, you
can cancel the operation and back up one step at a time.
You can return a phrase to the blank (empty) condition as
follows.
NOTE
Once deleted, a phrase cannot be restored. Use this function
with care.
1. From the main screen, press the [PROJECT/
UTILITY] key in the display section.
The indication “REC UTILITY” appears on the first line of the
display, and “PROJECT” is shown on the second line.
2. Use the cursor left/right keys to bring up the
indication “PHRASE” on the second line of
the display, and press the [ENTER] key.
The phrase screen appears on the display.
3. Turn the dial to select the phrase to erase.
4. Press the [FUNCTION] key in the function/
transport section once, to bring up the
indication “DELETE PHRASE” on the first line
of the display. Then press the [ENTER] key.
The display indication changes as follows.
5. To carry out the delete process, press the
[ENTER] key.
The phrase is deleted, and the phrase screen appears again.
By pressing the [EXIT] key instead of the [ENTER] key, you
can cancel the operation and back up one step at a time.
Copy to
No.3:PH000-03
Phrs1
åPhrs3
Copy?
Deleting a phrase
Phrase
No.1:PH001-01
No.1:PH001-01
Delete?
To Next Page
Loading...
