For WEP Authentication:
You can accept the default, WEP-Auto or select one of the available options.
Select WEP-Open to use Open System authentication. Select WEP-Shared to
use Shared Key authentication.
For WPA-PSK/WPA2-PSK Authentication:
You can select WPA-PSK/WPA2 PSK if your devices support both
authentication methods. Optionally, select WPA-PSK or WPA2-PSK if all
devices on your network support only one of these authentication methods.
Encryption
Select an Encryption method that corresponds to the Authentication method
that you chose.
If you chose a WPA-PSK/WPA2-PSK Authentication method:
Accept TKIP/AES encryption (the WPA-PSK/WPA2-PSK default), which supports
dynamic encryption keys using TKIP or AES algorithms, or choose one of
the other options.
Select AES if you chose WPA2-PSK for the authentication method.
Select TKIP if you chose WPA-PSK for the authentication method.
In the Security Key field, enter a 8 to 64 character key.
If you chose a WEP Authentication method:
Select WEP.
Key Format
We recommend using Hex because not all Ascii keys are compatible. Hex
keys use the numbers 0-9 and the letters A-F.
Encryption WEP Key 1, 2, 3, 4
If you selected Hex format and you chose a 128-bit key length, 26
hexadecimal values are required. Write the 26-hexadecimal key in the space
below for future reference, and then enter it in the Key 1 box.
— — — — — — — — — — — — —
— — — — — — — — — — — — —
If you selected Hex format and you chose a 64-bit key length, 10
hexadecimal values are required. Write the 10-hexadecimal key in the space
below for future reference, and then enter it in the Key 1 box.
— — — — — — — — — — — — —
If you selected ASCII format, and you chose a 128-bit key length, 13 ASCII
characters are required. Write the 13-ASCII-character key in the space
below for future reference, and then enter it in the Key 1 box.
— — — — — — — — — — — — —
Chapter 5: Using the Configuration Manager’s Advanced Program 47
To Next Page
Loading...
Need help?
General
