Zoom Wireless-N Router User Manual

Select the SNMP Version that your SNMP Management software supports.
WAN Access IP Address
Enter the IP address for WAN access.
The Routing Table Page
You can use the Routing Table page to enable/disable both Dynamic and Static Routing.
If routing is enabled, you can specify which physical interface address to use for
outgoing IP data grams. If you have more than one router and subnet, you will need to
define a routing table that lets packets find the proper routing path and allows different
subnets to communicate with each other. Most users do not need to set up Dynamic
or Static Routing.
Dynamic Routing
The Routing Information Protocol (RIP) will exchange information about
destinations for computing routes throughout the network. Please select
RIPv2 only if you have different subnet in your network. Otherwise, please
select RIPv1 if you need this protocol.
Static Routing
For static routing, you can specify up to eight routing rules. You can enter
the Destination IP address, Subnet Mask, Gateway, Hop for each routing rule.
Click the Enable checkbox to activate the routing table entry.
66 Wireless-N Router User Manual

Zoom Wireless-N Router Specifications

General

Brand	Zoom
Model	Wireless-N Router
Category	Wireless Router
Language	English