Status Page
The Status page shows you the status of the inbound and outbound Packet Filters and
the Domain Filters. Inbound, Outbound, and Domain filters are disabled, by default.
Packet Filtering Page
Packet Filtering allows you to control what packets are allowed to pass through the
router. Outbound Packet filters control outbound packets and Inbound Filtering
controls packets coming from the Internet. Inbound Filters applies only to packets
going to a Virtual Server or DMZ. Most users will not need to setup Packet Filtering.
When you click on Packet Filters from the left-side menu, it takes you to the
Outbound Packet Filtering page. If you need to set up an Inbound Filter, click on
Inbound Filter button at the bottom of the page.
Chapter 5: Using the Configuration Manager’s Advanced Program 55
To Next Page
Loading...
