Zoom Wireless-N Router User Manual

to http://www.zoomtel.com/mbsettings.
Authentication
Set to Auto, by default. Optionally, click Password Authentication Protocol
(PAP), or Challenge Handshake Authentication Protocol (CHAP), if supported
by your service provider.
Primary DNS and Secondary DNS
IP address of the Domain Name Servers. These addresses are provided by
your service provider.
Connection Control
Specifies the method for connecting or disconnecting the WAN session
based on network activity.
Auto Reconnect (always on) is the default. Other
options are
Connection-on-Demand or Manually.
Maximum Idle Time
Specifies the duration (in seconds) of inactivity before the device
disconnects. The default is
0, which disables this feature.
Keep Alive
Disabled by default. Select LCP Echo Request to keep the connection alive.
MTU
Sets the MTU (Maximum Transmission Unit). Most users should use the default value
of 0. The router selects the MTU size when set to 0.
Using your 3G modem as a Backup
You can use the Wireless-N Router and your mobile broadband modem to provide
Internet access if your DSL or Cable service stops working.
Note: To use this feature you must have a 3G modem installed.
To set up the 3G Failover, follow the instructions below:
1 You should have already set up your cable or DSL modem using the built in Setup
Wizard. If not, see Launching the Configuration Manager’s Setup Wizard on page 12.
2 Select Basic Settings from the Configuration Manager’s Advanced Page. See Launching
the Configuration Manager’s Advanced Program on page
41 if you don’t know how to
access the Advanced setting page.
3 On the Basic Setup page click the Check for Wan Connection box.
4 Enter an IP address in the Internet host textbox. This is the IP address that the router will
ping to verify that your DSL or Cable connection is active. (We recommend using your
Domain Name Server for this purpose.) To get the IP address of your Domain Name
server:
a Go to the Status page from the Zoom Configuration Manager.
Locate the Domain Name Server.
b In the WAN Status column, copy one of the displayed IP
addresses (either the primary or secondary DNS IP address).
44 Wireless-N Router User Manual

Zoom Wireless-N Router Specifications

General

Brand	Zoom
Model	Wireless-N Router
Category	Wireless Router
Language	English