ZyXEL Communications IES-22A - Page 249

Chapter 42 Commands
IES-708-22A User’s Guide
249
snmp getcommunity <community> Sets the SNMP GetRequest
community.
H/H
snmp setcommunity <community> Sets the SNMP SetRequest
community.
H/H
snmp trapcommunity <community> Sets the SNMP Trap community. H/H
snmp trusthost <ip> Sets the SNMP trusted host. Set
0.0.0.0 to trust all hosts.
H/H
. snmp trapdst set <index> <ip> [<port>] Sets the SNMP trap server and
listening port. Set 0.0.0.0 to not
send any SNMP traps.
H/H
snmp trapdst del <index> Deletes the SNMP trap server H/H
server show Displays the device’s service
status and port numbers.
M/L
server enable <telnet|ftp|web|icmp> Turns on a service. H/H
server disable <telnet|ftp|web|icmp> Turns off a service. H/H
server port <telnet|ftp|web> <port> Sets a port for a service. H/H
client show Displays the device’s secured
client settings.
M/L
client enable <index> Turns on a secure client. H/H
client disable <index> Turns off a secure client. H/H
client set <index> <start ip> <end
ip> [[telnet] [ftp] [web]
[icmp]]
Sets a secured client set: a range
of IP addresses from which you
can manage the device and the
protocols that can be used.
H/H
syslog show Displays the syslog settings. M/L
syslog enable Turns on the syslog logging. H/H
syslog disable Turns off the syslog logging. H/H
syslog server <ip> Sets the IP address of the syslog
server.
H/H
stdio show Displays Current Stdio Timeout. L/L
stdio set <minute|0:no timeout> Sets Current Stdio Timeout. H/H
time show Displays the system’s current
time.
L/L
time set <hh> [<mm> [ss]] Sets the system’s time. H/H
date show Displays the system’s current
date.
L/L
date set <yyyy> <mm> <dd> Sets the system’s date. H/H
timeserver show Displays the system’s time server. M/L
timeserver set <none> Sets the system to not use a time
server.
H/H
timeserver set <daytime> <ip> [nosync] Sets the time service protocol,
time server’s IP address.
H/H
timeserver set <time|ntp> <ip> <utc[<+|-
>0100~1200]> [nosync]
H/H
Table 89 Commands (continued)
CLASS COMMAND PARAMETERS DESCRIPTION P