ZyXEL Communications IES-22A - PPVC Member Delete Command; PPVC Member Show Command

Chapter 54 Virtual Channel Management
IES-708-22A User’s Guide
351
The following example adds a PVC to a PPVC with VPI 8 and VCI 35 for port 5. The PVC
uses VPI 8 and VCI 36. It sets the DEFVAL profile for downstream traffic shaping and for
upstream traffic policing. It uses priority queue 2.
54.4.3 PPVC Member Delete Command
Syntax:
ras> shdsl ppvc member delete <portlist> <vpi> <vci> <member vpi>
--> <member vci>
where
This command removes a PVC from a PPVC.
The following example removes a PVC that uses VPI 8 and VCI 36 from a PPVC with VPI 8
and VCI 35 for port 5.
54.4.4 PPVC Member Show Command
Syntax:
ras> shdsl ppvc member show [<portlist> [<vpi> <vci>]]
where
ras> shdsl ppvc member set 5 8 35 8 36 DEFVAL,DEFVAL 2
<portlist> =
The port(s) of the PPVC.
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<vpi> =
The VPI of the PPVC.
<vci> =
The VCI of the PPVC.
<member vpi> =
The VPI of the individual PVC that you are removing from the
PPVC.
<member vci> =
The VCI of the individual PVC that you are removing from the
PPVC.
ras> shdsl ppvc member delete 5 8 35 8 36
<portlist> =
The port(s) of the PPVC.
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<vpi> =
The VPI of the PPVC.
<vci> =
The VCI of the PPVC.