ZyXEL Communications IES-22A - DSL Port Disable Command; DSL Port Profile Show Command

Chapter 53 DSL Commands
IES-708-22A User’s Guide
330
where
This command forcibly enables the specified DSL port(s).
53.1.3 DSL Port Disable Command
Syntax:
ras> shdsl disable <portlist>
where
This command forcibly disables the specified DSL port(s).
" The factory default of all ports is enabled.
53.1.4 DSL Port Profile Show Command
Syntax:
ras> shdsl profile show [profile]
where
This command displays the specified DSL profile or all DSL profiles if you do not specify
one.
The following example displays the DSL DEFVAL profile.
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<profile> =
A profile name.
ras> shdsl profile show DEFVAL
01. DEFVAL
max rate (Kbps): 2304
min rate (Kbps): 192
annex mode : annexb
wire pair : 2wire
line probe : lp_off
curr margin (dB): 0
worst margin (dB): 0