ZyXEL Communications IES-22A - RPVC Gateway Set Command; RPVC Gateway Show Command

Chapter 54 Virtual Channel Management
IES-708-22A User’s Guide
355
• The subnet range of any RPVC and RPVC domain must be unique.
Use the following command sequence to configure the IES-708-22A for this example set up.
54.5.2 RPVC Gateway Set Command
Syntax:
ras> shdsl rpvc gateway set <gateway ip> <vlan id> [<priority>]
where
This command adds a gateway IP address to use for 2684 routed mode traffic.
The following example has the device use a VLAN ID of 1 and IEEE 802.1p priority of 3
when sending 2684 routed mode traffic to a gateway at IP address 192.168.10.102.
54.5.3 RPVC Gateway Show Command
Syntax:
ras> shdsl rpvc gateway show
This command displays
the gateway IP addresses that are configured for use with 2684
routed mode traffic.
The following is an example.
ras> shdsl rpvc gateway set 192.168.10.102 1
ras> shdsl rpvc set 1 8 35 DEFVAL 192.168.10.200/32 192.168.10.102
ras> shdsl rpvc route set 1 8 35 10.10.10.1/24
<gateway ip> =
The IP address of the gateway to which you want to send the
traffic that the system receives from this PVC. Enter the IP
address in dotted decimal notation.
<vlan id> =
The VLAN Identifier to add to Ethernet frames that the system
routes to this gateway.
[<priority>] =
Set the IEEE 802.1p priority (0~7) to add to the traffic that you
send to this gateway.
ras> shdsl rpvc gateway set 192.168.10.102 1 3
ras> shdsl rpvc gateway show
gateway ip vid priority
--------------- ---- --------
192.168.10.102 1 3