ZyXEL Communications IES-22A - VLAN Enable; VLAN Disable; VLAN Show Command

Chapter 46 IEEE 802.1Q Tagged VLAN Commands
IES-708-22A User’s Guide
291
46.5 VLAN Enable
Syntax:
ras> switch vlan enable <vid>
This command enables the specified VLAN ID in the SVLAN (Static VLAN) table.
46.6 VLAN Disable
Syntax:
ras> switch vlan disable <vid>
This command disables the specified VLAN ID in the SVLAN (Static VLAN) table.
46.6.1 VLAN Show Command
Syntax:
ras> switch vlan show <vlanlist>
where
This command shows information about the specified port’s VLAN settings.
The following example shows the settings for all VIDs.
<vlanlist> =
You can specify a single VID: <1>, all VIDs: <*>, a list of
VIDs: <1,3>, you can also include a range of VIDs: <1,5,6~8>.
ras> switch vlan show *
vid name F:fixed X:forbidden N:normal U:untag T:tag
---- ---------------- ----------------------------------------------------
1 -
enabled 12345678 12
FFFFFFFF FF
UUUUUUUU UU