ZyXEL Communications IES-22A - Route Delete Command; Route Show Command

Chapter 50 IP Commands
IES-708-22A User’s Guide
317
where
This command defines a new, static IP forwarding route or edits an existing one.
50.3.4 Route Delete Command
Syntax:
ras> ip route delete <dst ip>[/netmask]
where
This command removes a static, IP forwarding route.
50.3.5 Route Show Command
Syntax:
ras> ip route show
This command displays the IES-708-22A’s routing table.
An example is shown next.
<dst ip> =
The destination IP address of packets that this static route is to
route.
[/netmask] =
The destination subnet mask of packets that this static route is to
route.
<gateway ip> =
The IP address of the gateway that you want to send the packets
through.
[metric] =
The metric (hop count) of this static route.
<name> =
A name to identify this static route. Up to 31 English keyboard
characters. Spaces and tabs are not allowed.
default =
Use this to configure the IES-708-22A’s default route.
<dst ip> =
The destination IP address of packets to which this static route
applies.
[/netmask] =
The destination subnet mask of packets to which this static route
applies.
ras> ip route show
index dest gateway metric name
----- --------------- --------------- ------ -------------------------------
1 192.168.1.0/24 192.168.1.1 1
2 default 192.168.1.254 1