ZyXEL Communications IES-22A - VLAN CPU Show Command; VLAN CPU Set Command

Chapter 46 IEEE 802.1Q Tagged VLAN Commands
IES-708-22A User’s Guide
289
" The IES-708-22A accepts both tagged and untagged incoming frames on the
Ethernet ports.
The following example sets the IES-708-22A to accept only VLAN tagged Ethernet frames on
DSL port 3.
46.4.6 VLAN CPU Show Command
Syntax:
ras> switch vlan cpu show
This command displays the management VLAN (CPU). You can only use ports that are
members of this management VLAN to manage the IES-708-22A.
The following example shows the management VLAN.
46.4.7 VLAN CPU Set Command
Syntax:
ras> switch vlan cpu set <vid> [priority]
where
This command sets the management VLAN (CPU). You can only use ports that are members
of this management VLAN in order the IES-708-22A.
The following example sets VLAN ID 2 to be the CPU (management) VLAN.
ras> switch vlan frametype 3 tag
ras> switch vlan cpu show
host join vlan: 1
host priority: 0
<vid> =
The VLAN ID. Valid parameter range = [1 – 4094].
[<priority] =
This is the priority value (0 to 7) to use for incoming frames
with an IEEE 802.1Q VLAN tag.
ras> switch vlan cpu set 2