ZyXEL Communications IES-22A - ACL Assignment Show Command

Chapter 55 ACL Commands
IES-708-22A User’s Guide
373
where
This command allows you to remove an ACL profile from the specified PVC.
55.2.3 ACL Assignment Show Command
Syntax:
ras> switch acl show [<portlist>] [<vpi> <vci>]
where
This command displays the current ACL profiles applied to the specified PVC(s). The
following figure shows an example.
<portlist> =
The port number of the PVC. You can specify a single DSL port
<1>, all DSL ports <*> or a list of DSL ports <1,3,5>. You can
also include a range of ports <1,5,6~8>.
<vpi> =
The VPI of the PVC.
<vci> =
The VCI of the PVC.
<profile> =
The name of the ACL profile.
<portlist> =
The port number of the PVC. You can specify a single DSL port
<1>, all DSL ports <*> or a list of DSL ports <1,3,5>. You can
also include a range of ports <1,5,6~8>.
<vpi> =
The VPI of the PVC.
<vci> =
The VCI of the PVC.
ras> switch acl show
port vpi vci type profile
---- --- ----- ---- --------------------------------
1 0 33 PVC test