ZyXEL Communications IES-22A - Alarm Profile Map Command; Alarm Profile Showmap Command

Chapter 53 DSL Commands
IES-708-22A User’s Guide
342
The following example deletes the SESalarm alarm profile.
53.3.4 Alarm Profile Map Command
Syntax:
ras> shdsl alarmprofile map <portlist> <profile> <span|stuc|stur|*>
where
Sets the IES-708-22A to use an (already-configured) alarm profile with the specified DSL
ports.
The following example sets the IES-708-22A to use the
SESalarm alarm profile for the STU-
C end point with DSL port 5.
53.3.5 Alarm Profile Showmap Command
Syntax:
ras> shdsl alarmprofile showmap <portlist>
where
Displays which alarm profiles the IES-708-22A is set to use for specific (or all) DSL ports.
ras> shdsl alarm profile delete SESalarm
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<profile> =
The name of an alarm profile.
<span|stuc|stur
|*>
=
The type of alarm profile the specified alarm profile is for the
specified ports. The alarm profile can apply for the whole span
(
span), the STU-C end point (stuc), the STU-R end point
(
stur), or all STU-C and STU-R end points (*).
ras> shdsl alarmprofile map 5 SESalarm stuc
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.