ZyXEL Communications IES-22A - IGMP Bandwidth Port Enable Command; IGMP Bandwidth Port Set Command; IGMP Bandwidth Port Show Command

Chapter 48 IGMP Commands
IES-708-22A User’s Guide
305
48.5.2 IGMP Bandwidth Port Enable Command
Syntax:
ras> switch igmpsnoop bandwidth port enable <portlist>
where
This command activates multicast bandwidth setting on the specified port.
48.5.3 IGMP Bandwidth Port Set Command
Syntax:
ras> switch igmpsnoop bandwidth port set <portlist> <bandwidth>
where
This command sets the bandwidth allowed for multicast traffic on the specified port(s). It does
not automatically enable it, however.
48.5.4 IGMP Bandwidth Port Show Command
Syntax:
ras> switch igmpsnoop bandwidth port show <portlist>
where
This command displays the multicast bandwidth setting on the specified port(s) and whether
or not this setting is active. The following example displays the bandwidth budget for port 1.
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<bandwidth> =
1..100000, in units of kbps
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
ras> switch igmpsnoop bandwidth port show 1
port enable bandwidth
------ ------ -----------
1 - 4096