ZyXEL Communications IES-22A - RPVC Delete Command; RPVC Route Set Command

Chapter 54 Virtual Channel Management
IES-708-22A User’s Guide
358
The following example displays the RPVCs for DSL port 1.
54.5.7 RPVC Delete Command
Syntax:
ras> shdsl rpvc delete <portlist> <vpi> <vci>
where
This command removes a PVC for 2684 routed mode traffic.
The following example removes a PVC for 2684 routed mode traffic. It is for DSL port 1, VPI
8, VCI 35.
54.5.8 RPVC Route Set Command
Syntax:
ras> shdsl rpvc route set <port number> <vpi> <vci> <ip>/<netmask>
where
ras> shdsl rpvc show 1
port vpi vci ip/netmask gateway ip DS/US vcprofile
---- --- ---- ------------------ --------------- ---------------------------
1 8 35 192.168.10.200/32 192.168.10.102 DEFVAL/DEFVAL
<portlist> =
The port(s) of the RPVC.
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<vpi> =
The VPI of the RPVC.
<vci> =
The VCI of the RPVC.
ras> shdsl rpvc delete 1 8 35
<port number> =
The port of the RPVC. Specify a single DSL port <1>.
<vpi> =
The VPI of the RPVC.
<vci> =
The VCI of the RPVC.