ZyXEL Communications IES-22A - MAC Filter Set Command; MAC Filter Delete Command; MAC Count Commands

Chapter 47 MAC Commands
IES-708-22A User’s Guide
295
This command sets whether the IES-708-22A allows or blocks access for the MAC addresses
you specify.
The following example sets DSL port 5 to allow frames from the MAC addresses specified for
DSL port 5.
47.2.5 MAC Filter Set Command
Syntax:
ras> switch mac filter set <port> <mac> [<mac> <mac> ...]
where
This command adds an allowed source MAC address on the specified DSL port.
The following example adds source MAC address 00:a0:c5:12:34:56 for DSL port 5.
47.2.6 MAC Filter Delete Command
Syntax:
ras> switch mac filter delete <port> <mac> [<mac> <mac> ...]
where
This command removes a configured source MAC address from the DSL port that you specify.
The following example removes the source MAC address of 00:a0:c5:12:34:56 from the MAC
filter for DSL port 5.
47.3 MAC Count Commands
This feature is available in STU-C mode only.
ras> switch mac filter mode 5 accept
<port> =
The number of a DSL port.
<mac> =
The source MAC address in "00:a0:c5:12:34:56" format.
ras> switch mac filter set 5 00:a0:c5:12:34:56
<port> =
The number of a DSL port.
<mac> =
The source MAC address in "00:a0:c5:12:34:56" format.
ras> switch mac filter delete 5 00:a0:c5:12:34:56